637 research outputs found
The K2K SciBar Detector
A new near detector, SciBar, for the K2K long-baseline neutrino oscillation
expe riment was installed to improve the measurement of neutrino energy
spectrum and to study neutrino interactions in the energy region around 1 GeV.
SciBar is a 'fully active' tracking detector with fine segmentation consisting
of plastic scintillator bars. The detector was constructed in summer 2003 and
is taking data since October 2003. The basic design and initial performance is
presented.Comment: 7 pages, 4figures, Contributed to Proceedings of the 10th Vienna
Conference on Instrumentation, Vienna, February 16-21, 200
Evidence for a vector charmonium-like state in
We report the measurement of via
initial-state radiation using a data sample of an integrated luminosity of
921.9 fb collected with the Belle detector at the and
nearby. We find evidence for an enhancement with a 3.4 significance in
the invariant mass of The measured mass and width
are
and ,
respectively. The mass, width, and quantum numbers of this enhancement are
consistent with the charmonium-like state at 4626 MeV/ recently reported
by Belle in The product of the cross section and the branching fraction of
is measured from
threshold to 5.6 GeV.Comment: 9 pages, 4 figure
A Long Baseline Neutrino Oscillation Experiment Using J-PARC Neutrino Beam and Hyper-Kamiokande
Document submitted to 18th J-PARC PAC meeting in May 2014. 50 pages, 41 figuresDocument submitted to 18th J-PARC PAC meeting in May 2014. 50 pages, 41 figuresDocument submitted to 18th J-PARC PAC meeting in May 2014. 50 pages, 41 figuresHyper-Kamiokande will be a next generation underground water Cherenkov detector with a total (fiducial) mass of 0.99 (0.56) million metric tons, approximately 20 (25) times larger than that of Super-Kamiokande. One of the main goals of Hyper-Kamiokande is the study of asymmetry in the lepton sector using accelerator neutrino and anti-neutrino beams. In this document, the physics potential of a long baseline neutrino experiment using the Hyper-Kamiokande detector and a neutrino beam from the J-PARC proton synchrotron is presented. The analysis has been updated from the previous Letter of Intent [K. Abe et al., arXiv:1109.3262 [hep-ex]], based on the experience gained from the ongoing T2K experiment. With a total exposure of 7.5 MW 10 sec integrated proton beam power (corresponding to protons on target with a 30 GeV proton beam) to a -degree off-axis neutrino beam produced by the J-PARC proton synchrotron, it is expected that the phase can be determined to better than 19 degrees for all possible values of , and violation can be established with a statistical significance of more than () for () of the parameter space
Plastisol Foaming Process. Decomposition of the Foaming Agent, Polymer Behavior in the Corresponding Temperature Range and Resulting Foam Properties
The decomposition of azodicarbonamide, used as foaming agent in PVC - plasticizer (1/1) plastisols was studied by DSC. Nineteen different plasticizers, all belonging to the ester family, two being polymeric (polyadipates), were compared. The temperature of maximum decomposition rate (in anisothermal regime at 5 K min-1 scanning rate), ranges between 434 and 452 K. The heat of decomposition ranges between 8.7 and 12.5 J g -1. Some trends of variation of these parameters appear significant and are discussed in terms of solvent (matrix) and viscosity effects on the decomposition reactions. The shear modulus at 1 Hz frequency was determined at the temperature of maximum rate of foaming agent decomposition, and differs significantly from a sample to another. The foam density was determined at ambient temperature and the volume fraction of bubbles was used as criterion to judge the efficiency of the foaming process. The results reveal the existence of an optimal shear modulus of the order of 2 kPa that corresponds roughly to plasticizer molar masses of the order of 450 ± 50 g mol-1. Heavier plasticizers, especially polymeric ones are too difficult to deform. Lighter plasticizers such as diethyl phthalate (DEP) deform too easily and presumably facilitate bubble collapse
Studying the Underlying Event in Drell-Yan and High Transverse Momentum Jet Production at the Tevatron
We study the underlying event in proton-antiproton collisions by examining
the behavior of charged particles (transverse momentum pT > 0.5 GeV/c,
pseudorapidity |\eta| < 1) produced in association with large transverse
momentum jets (~2.2 fb-1) or with Drell-Yan lepton-pairs (~2.7 fb-1) in the
Z-boson mass region (70 < M(pair) < 110 GeV/c2) as measured by CDF at 1.96 TeV
center-of-mass energy. We use the direction of the lepton-pair (in Drell-Yan
production) or the leading jet (in high-pT jet production) in each event to
define three regions of \eta-\phi space; toward, away, and transverse, where
\phi is the azimuthal scattering angle. For Drell-Yan production (excluding the
leptons) both the toward and transverse regions are very sensitive to the
underlying event. In high-pT jet production the transverse region is very
sensitive to the underlying event and is separated into a MAX and MIN
transverse region, which helps separate the hard component (initial and
final-state radiation) from the beam-beam remnant and multiple parton
interaction components of the scattering. The data are corrected to the
particle level to remove detector effects and are then compared with several
QCD Monte-Carlo models. The goal of this analysis is to provide data that can
be used to test and improve the QCD Monte-Carlo models of the underlying event
that are used to simulate hadron-hadron collisions.Comment: Submitted to Phys.Rev.
Measurement of the Dipion Mass Spectrum in X(3872) -> J/Psi Pi+ Pi- Decays
We measure the dipion mass spectrum in X(3872)--> J/Psi Pi+ Pi- decays using
360 pb-1 of pbar-p collisions at 1.96 TeV collected with the CDF II detector.
The spectrum is fit with predictions for odd C-parity (3S1, 1P1, and 3DJ)
charmonia decaying to J/Psi Pi+ Pi-, as well as even C-parity states in which
the pions are from Rho0 decay. The latter case also encompasses exotic
interpretations, such as a D0-D*0Bar molecule. Only the 3S1 and J/Psi Rho
hypotheses are compatible with our data. Since 3S1 is untenable on other
grounds, decay via J/Psi Rho is favored, which implies C=+1 for the X(3872).
Models for different J/Psi-Rho angular momenta L are considered. Flexibility in
the models, especially the introduction of Rho-Omega interference, enable good
descriptions of our data for both L=0 and 1.Comment: 7 pages, 4 figures -- Submitted to Phys. Rev. Let
Precision measurement of the top quark mass from dilepton events at CDF II
We report a measurement of the top quark mass, M_t, in the dilepton decay
channel of
using an integrated luminosity of 1.0 fb^{-1} of p\bar{p} collisions collected
with the CDF II detector. We apply a method that convolutes a leading-order
matrix element with detector resolution functions to form event-by-event
likelihoods; we have enhanced the leading-order description to describe the
effects of initial-state radiation. The joint likelihood is the product of the
likelihoods from 78 candidate events in this sample, which yields a measurement
of M_{t} = 164.5 \pm 3.9(\textrm{stat.}) \pm 3.9(\textrm{syst.})
\mathrm{GeV}/c^2, the most precise measurement of M_t in the dilepton channel.Comment: 7 pages, 2 figures, version includes changes made prior to
publication by journa
- …